první chyba. Standard flashovat nemůžeš. Napřed mělo jít mini, a teprve poté standard.

edit: nepochopil jsem, která z níže vypsaných možností to je:

When the web interface is no longer available, switch the router off first (remove the power jack) and remove all network cables from the equipment. After some seconds you restart the WRT54G. Now take note of the flashing LEDs.

1. The power LED flashes very fast. If it keeps on flashing longer than 2 minutes, without having lit up the other LED's, then a defective bootloader is present. However, if you can ping 192.168.1.1 (your router IP) you can try the TFTP recovery, otherwise you may need to open the router and use the JTAG recovery method below.
2. The power LED flashes very fast and after some seconds the DMZ LED lights up for approximately 5 seconds. In this case the Bootloader is intact and only the kernel (firmware) is defective. In this case you could possibly still recover with an ethernet cable if you reflash the firmware via TFTP (see TFTP below).
3. The power LED flashes very fast and after about 20 seconds it lights permanently, but the DMZ LED did not light up. In this case Bootloader and Kernel (firmware) are intact, only a wrong configuration from locked up the router. This can happen if