SB5101 Key Features
- Remote Management via SNMP and Remote Configuration via TFTP
- Software upgradeable over the network

- The Cable Modem has three active interfaces, the HFC, the Ethernet and the USB and each interface has both a MAC and an IP address associated with it. When operating normally it is the IP address of the HFC interface that is used for diagnostic access to the modem. However the IP address associated with the Ethernet interface is always available to the client side network, unless it has been disabled by management command. This means that a PC on the client side can access the WEB pages within the modem using the reserved address 192.168.100.1. This is a non-routed address so it cannot be reached from the Internet (routed) side of the network