Dostal jsi 2x odkaz na servisni manual v PDF. Koukal ses do nej ? Asi vubec ne. Jinak by ses docetl...

Removing the Keyboard Cover
Required Equipment
• 1 Phillips screwdriver
• Small flat-blade screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. Remove the two M2.5×4.0mm hinge cover screws that secure the keyboard cover to the rear
of the notebook.
3. Carefully insert a flat-blade screwdriver blade under the keyboard cover near the right end, then near
the center, then near the left end, and then gently lift up the center of the cover. Gently pry up the hinge
covers if needed, being careful not to damage the plastics or wireless antenna underneath
4. If necessary, while holding the center of the cover, carefully insert the flat-blade screwdriver under
the right side of the display assembly hinge, gently pry up, and then lift the cover out. This procedure
might need to be repeated on the left side of display assembly hinge to completely remove the cover.

Removing the Speaker Assembly
(User-Replaceable)
NOTE: The following speaker assembly removal procedures apply only to HP Pavilion 4x00,
HP Compaq nx9005 and nx9000, Compaq Evo Notebook N1050v and N1010v, and
Compaq Presario 2100 and 1100 Series notebooks. The HP Pavilion ze5x00, HP Compaq nx9010
and nx9008, and Compaq Presario 2500 Series notebook speakers are integrated into the top case.
Refer to the “Removing the Top Case” section later in this chapter for procedures on removing the
top case and speakers on the HP Pavilion 5x00, HP Compaq nx9010 and nx9008, and Compaq Presario
2500 Series notebooks.
Required Equipment
1 Phillips screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. Remove the keyboard cover (page 2-13).
3. Remove the M2.5×6.0mm screw that secures the speaker assembly to the top case.
4. Disconnect the 4-wire cable from the switchboard PCA.